- MB-1461 Clay Clipboard
- SC-15 Tuxedo
- SC-16 Cotton Tail
- SC-30 Blue Dawn
- SC-34 Down To Earth
- SC-50 Orange Ya Happy
- SC-60 Silver Lining
- SC-74 Hot Tamale
- NT-CLR Clear Dipping Glaze
- SL-444 Argyle
- CB-604 #4 Soft Fan
- CB-110 #10/0 Liner
- CB-106 #6 Script Liner
- AC-230 Clay Carbon Paper
- 2" Foam Roller
- Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
- Place the pattern on top of the AC-230 Clay Carbon Paper onto the bisque. Trace around the pattern with a pen or pencil.
- Place SL-444 Argyle Stencil on the clipboard. Using the Foam roller, gently apply SC-30 Blue Dawn over the stencil. Continue to add on to the rolled stencil to cover the clipboard with the design. Tip: Hold the tip of the roller to apply the color to keep the glaze from bleeding under the stencil.
- Use the CB-106 #6 Script Liner to apply 2-3 coats of SC-16 Cotton Tail onto the snow area of the snowman. Use the same brush to apply three coats of SC-74 Hot Tamale to the scarf and hat band. Apply two caots of SC-50 Orange Ya Happy to the nose and three coats of SC-15 Tuxedo to the hat. Apply coat of SC-34 Down to Earth to the arm. Use CB-106 Script Liner or CB-110 Liner to apply color.
- Shade the left side of the snow on the snowman with SC-60 Silver LIning, dot the scarf with SC-16 Cotton Tail, by using the end of a brush handle, dot eyes and buttons with the end of the brush handle. Use the CB-110 #10/0 Liner with SC-15 Tuxedo to outline the design.
- Use the Script Liner to apply SC-15 to the edges of the clipboard.
- Dip in NT-CLR.
- Stilt and fire to cone 05/06.
- Glue the clip onto the clipaboard with epoxy. Follow the directions on the back of the package.