Sculpting Medium Lily


Products Used

  • MB-1298 Flat Vase
  • SC-12 Moody Blue
  • SC-15 Tuxedo
  • SC-52 Toad-ily Green
  • SC-74 Hot Tamale
  • SC-88 Tu Tu Tango
  • SC-94 Curry Around
  • FN-018 Bright Blue
  • SG-501 Sculpting Medium
  • S-2101 Crystal Clear Brushing
Decorating Accessories
  • CB-110 - #10/0 Liner
  • CB-106 - #6 Script Liner
  • CB-604 - #4 Soft Fan
  • BT-910 - Synthetic Sponges
  • AC-230 - Clay Carbon Paper
Additional Materials
Project Info




  1. Begin with properly fired shelf cone 04 bisque.  Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using a CB-604 # 4 Soft Fan, apply 3 coats of SC-94 Curry Around down inside the neck of the vase.
  3. Place some S-2101 Crystal Clear Brushing into a small cup and add a little bit of water to slightly dilute it (about 3 parts glaze and 1 part water).  It should be the consistency of a coffee cream.  Pour this into the vase and roll around to completely coat the interior of the vase.  Drain out the excess glaze and keep vase inverted until it has lost its shine. Wipe off any glaze from the outside using a damp sponge. Allow to dry.
  4. Using a CB-604 #4 Soft Fan, apply 3 coats of FN-018 Bright Blue to the outside of the vase. Allow to dry.
  5. With a pencil and AC-230 Clay Carbon Paper, trace on the pattern.
  6. With a palette knife or a brush, pile on SG-501 Sculpting Medium to the design. Allow to dry.
  7. Using a CB-106 #6 Script Liner, apply 2 coats of SC-94 Curry Around to the flower petals and the center with SC- 88 Tu Tu Tango and the stem with SC-52 Toad-ily Green.
  8. Using a CB-106 #6 Script Liner, float SC-88 Tu Tu Tango on the flower petals to shade and SC-74 Hot Tamale to the center.
  9. Using a CB-106 #6 Script Liner, float SC-12 Moody Blue around the flower and the stem.
  10. Using a CB-110 #10/0 Liner, outline and detail the design with SC-15 Tuxedo. Allow to dry.
  11. Stilt and fire to shelf cone 05/06.