Simple Ring Holder


Products Used

  • MB-1254 - Ring/Soap Holder
  • FN-001 - White
  • SC-11 - Blue Yonder
  • SC-77 - Glo-Worm
Decorating Accessories
  • BT-910 - Synthetic Sponges
  • CB-106 - #6 Script Liner
  • CB-604 - #4 Soft Fan
Additional Materials
  • Paper Towel
  • ⅛" Masking Tape
  • Copy Paper
  • Rectangular Paper Punch (or other design)
Project Info
  • Designer: Marcia Roullard
  • Skill Level: Basic
  • Time: 1 hour


  1. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using a CB-604 #4 Soft Fan, apply 2 coats of FN-001 White on the piece.
  3. Punch out several paper rectangles (or any pattern you wish to use). Starting in the middle of the piece, wet the paper rectangle and place onto the piece. Skip a space and place the next rectangle. Do the same on both sides, these will slightly overhang the edge of the piece. Press with a paper towel to absorb any excess water.
  4. Using a CB-604 #4 Soft Fan, apply 3 coats of SC-77 Glo-Worm on the top and back of the piece except the ring holder. Remove the paper rectangles when the last coat of glaze looses its shine.
  5. Create a spiral stripe on the ring holder using the ⅛" masking tape.
  6. Using a CB-106 #6 Script Liner, apply 3 coats of SC-11 Blue Yonder on to the ring holder. Remove the masking tape when the last coat of glaze looses its shine. Allow to dry.
  7. Stilt and fire to shelf cone 06.

Who We Are

Our purpose, history and policies

About Us Warranty & Freeze Policy

Site Map

Where To Buy

Looking for a ceramic studio, retailer or wholesaler?

Find a Location

Project Library

Step by Step Instructions from the Professionals at Mayco.

Project library

New Projects