Wild Roses Tray


Products Used

  • MB-1307 Handled Platter
  • SC-1 Pink-A-Boo
  • SC-14 Java Bean
  • SC-24 Dandelion
  • SC-26 Green Thumb
  • SC-34 Down To Earth
  • SC52 Toad-ily Green
  • SC-63 Popeye's Favorite
  • SC-89 Cutie Pie Coral
  • SG-405 Brown Designer Liner
  • FN-001 White
  • FN-008 Brown
Decorating Accessories
  • CB-106 #6 Script Liner
  • CB-110 #10/0 Liner
  • CB-310 #10 Flat Shader
  • CB-404 #4 Pointed Round
  • CB-406 #6 Pointed Round
  • CB-604 #4 Soft Fan
  • BT-910 Synthetic Sponge
  • AC-230 Clay Carbon Paper
Additional Materials
Project Info
  • Designer: Bob Moreni
  • Skill Level: Basic
  • Time: 2½ hours


  1. Begin with properly fired shelf cone 04 bisque.  Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using a CB-604 #4 Soft Fan, apply 2 coats of FN-001 White to the top surface of the platter.  Allow to dry.
  3. With a pencil and AC-230 Clay Carbon Paper, trace on the pattern (just the outline not the detail). You will need to extend the pattern on the one side.
  4. Using a CB-406 #6 Pointed Round and a CB-404 #4 Pointed Round, apply 2-3 coats of SC-1 Pink-A-Boo to all flowers and buds. Allow to dry.
  5. If needed re-trace the just the flower pattern outline.
  6. Using a CB-310 #10 Flat Shader, shade all flower petals and buds with SC-89 Cutie Pie Coral.
  7. With the end of a brush handle, place a dot of SC-24 Dandelion in the small flower centers.
  8. Using a CB-406 #6 Pointed Round, apply 3 coats of SC-52 Toad-ily Green to all the leaves.
  9. Using a CB-310 Flat Shader, Shade the one side of the leaves with SC-26 Green Thumb and the other side with SC-63 Popeye’s Favorite.
  10. Using a CB-106 #6 Script Liner and a CB-110 #10/0 Liner apply 2 coats of SC-14 Java bean to all stems and branches. Apply a third coat with the brush loaded with SC-14 Java Bean and side load with SC-34 Down to Earth to shade the stems and branches.
  11. Using a CB-110 #10/0 Liner, outline and detail all flowers, buds and leaves with SG-405 Brown Designer Liner. Allow to dry.
  12. Using a CB-604 #4 Soft Fan, apply 1 coat of S-2101 Crystal Clear Brushing to the top of the platter. Allow to dry.
  13. Using a CB-604 #4 Soft Fan, apply 3 coats of FN-008 Brown to the back of the platter. Allow to dry.
  14. Stilt and fire to shelf cone 06/05.

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers


PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904


Technical Support