- Last Updated: Tuesday, 25 November 2014 21:04
- SB-100 16 oz. Mug
- SB-104 Rimmed Salad Plate
- SB-105 Rimmed Dinner Plate
- SB-106 Rimmed Bowl
- SW-001 Clear
- SW-111 Wrought Iron
- SW-124 Matte Maycoshino
- SW-302 Rutile
- AC-310 Silkscreen Medium
- BT-910 Synthetic Sponge
- CB-604 #4 Soft Fan
- DSS-0112 Flowers
- Palette Knife
- Download: Silkscreen Instructions
- Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
- On the palette with a palette knife, mix AC-230 Silkscreen Medium with SW-302 Rutile to thicken to the consistency of peanut butter.
- Tip: Review the Silkscreen Instructions for further details and how to properly clean the screen for additional use.
- Using the flowers from DSS-0112 Flowers, rub the thickened SW-302 Rutile mixture over the screen, grain side up. Repeat process until desired amount of flower images have been screened on all 4 stoneware bisque pieces.
- Using CB-604 #4 Soft Fan, apply 3 coats of SW-124 Matte Maycoshino over the screenprinted images on SB-100 16 oz. Mug, SB-104 Rimmed Salad Plate, SB-105 Rimmed Dinner Plate and SB-106 Rimmed Bowl. Brush on glaze in various directions as the brush strokes may show. Allow glaze to lose its shine between coats.
- Using CB-604 #4 Soft Fan, apply 3 coats of SW-111 Wrought Iron to the backside of SB-104 Rimmed Salad Plate, SB-105 Rimmed Dinner Plate and the exterior of SB-106 Rimmed Bowl. Also apply 3 coats of SW-111 Wrought Iron to the interior, handle and exterior surface of the SB-100 16 oz. Mug above and below the silkscreened area. Do not apply glaze to the feet of the bisque pieces. Allow glaze to lose its shine between coats.
- Clean off any glaze from the feet of each piece.
- Sit each cleaned, bisque piece onto kiln shelf and fire to shelf cone 6.