Handled Bowl Glaze Combo


Products Used

  • SB-111 Handled Bowl
  • SW-106 Alabaster
  • SW-125 Purple Mint
  • SW-127 Olivine
  • SW-128 Cordovan
Decorating Accessories
  • CB-604 #4 Soft Fan
  • BT-910 Synthetic Sponges
Additional Materials
  • Pencil
  • Slip Trailer (Xiem Studio Tools)
Project Info
  • Designer: Marcia Roullard


  1. Begin with properly fired shelf cone 04 bisque.  Moisten a clean sponge and wipe bisque to remove any dust.
  2. Load a slip trailer with SW-128 Cordovan.
  3. On the inside edge of the bowl, make fat inverted loops with a slip trailer, two rows, it will be necessary to rest the bowl on an angle so the loop will keep its shape till the glaze is set. Apply 2 coats. Allow to dry
  4. Using a CB-604 #4 Soft Fan, apply 2 coats of SW-127 Olivine to the entire piece. Allow for your glaze to fully dry in between each coat.
  5. When the glaze is dry, apply 2 coats of SW-106 Alabaster to the entire piece. Recede the second coat on the outside of the bowl.
  6. After applying the 2nd coat of SW-106, and while the glaze is still wet, apply 1 coat of SW-125 Purple Mint to the entire piece. Recede from the bottom of the bowl for this coat.
  7. With a damp sponge, wipe off any excess glaze off the foot of bowl.
  8. Place unstilted, on a high-fired, kiln washed kiln shelf.
  9. Fire to shelf cone 5/6.

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers


PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904


Technical Support