Sliced Funky Tree

 

CD1095 sc98 sg704 crop

Products Used

Bisque
  • CD-1095 Funky Tree
Color
  • SC-98 Slime Time,
  • SG-704 Specta-Clear Peppermint

Decorating Accessories

  • CB-604 Soft Fan

Miscellaneous Accessories

  • Exacto Knife
  • multicolor bulbs (Hobby Hobby)
 
Designer: Elizabeth Carey
 

Instructions

  1. Cast in a low fire body clay, while wet cut out slices of the tree as shown in the picture. Make a grove in the base to allow the cord to fit so the tree will stand flat. Clean with a wet brush to smooth the cutouts, remove the seamline while wet.

  2. Fire to 04.

  3. Thin SC-98 Slime Time with water so it is a pouring consistency, pour to the inside of the tree, make sure all the surface is covered, brush out the drips on the outside of the tree.

  4. Brush three coats of SC-98 Slime Time to the outside of the tree including the base with the fan brush

  5. Stir and shake SG-704 Peppermint well, brush one coat to the outside of the tree using the fan brush.

  6. Fire to 05/06.

  7. Bulbs were purchased at Hobby Lobby, wire to the tree on the back so they don’t fall to the bottom. Pier One sells clear bubble lights that would also look great in the tree

Who We Are

Our purpose, history, and policies

About Us

Site Map

Warranty & Freeze Policy

Where To Buy

Find the best place to purchase Mayco products

Dealers & Retailers

Distributors

PYOP & Ceramic Studios 

Contact Us

 (614) 876-1171 |   (614) 876-9904

info@maycocolors.com

Technical Support

614-675-2031

technical@maycocolors.com