Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
Squeeze around ¼ cup of SC-42 Butter Me Up into the disposable cup. Thin with water until it is easily poured. Pour into the vase and rotate until the inside is covered. Pour out the excess.
Squeeze around 2 TBS of SC-42 Butter Me Up, SC-16 Cotton Tail and SC-60 Silver Lining onto the palette.
Use the same Soft Fan for all steps – do not clean.
Dip the Soft Fan into SC-42 Butter Me Up and apply 1 coat to the upper row of facets on the vase.
Dip the brush into SC-16 Cotton Tail and shade down to the next row of facets.
Dip the brush into SC-60 Silver Lining and shade halfway down the next row of facets.
Dip the brush into SC-16 Cotton Tail and shade halfway down the last row of facets.
Dip the brush into SC-42 Butter Me up and shade down to the bottom of the vase.
Repeat Step #4 two times for a total of 3 coats. Allow glaze to dry.
Place the pattern and AC-230 Clay Carbon Paper on the center of the vase. Trace with the pencil.
Using the Detail Liner with SC-15 Tuxedo, apply 1 coat to the lettering and stars.
