“Spin, Drop and Coat” Stroke & Coat and Flux Trailing Bowl

Designer: Carmen Allen



  1. Begin with soft fired stoneware bisque. 
  2. Moisten a clean sponge and wipe bisque to remove any dust. 
  3. Replace the SC-10 Teal Next Time cap with an AC-224 Plastic Detailer Cap and trail along the top edge of the bowl, creating a series of “w”s. We applied 2 rows.  
  4. Fill an AC-223 Large Writer Tip kit with SW-401 Light Flux. Apply dots of Flux inside of the “w”s from the SC. 
  5. Allow the glaze to dry from steps 3 and 4 and repeat! 
  6. Once all of the trailing has dried, use a fan brush to apply 2 coats of SW-253 Green Opal to the inside of the bowl. 
  7. Use a soft fan to apply 2 coats of SW-110 Oyster to the inside of the bowl and 3 coats to the outside, avoiding the foot. 
  8. Use a clean sponge to wipe the excess glaze off of the foot. 
  9. Fire to cone 5/6. (Sample was fired to cone 6) 



  • SB-106 Rimmed Bowl 


  • SW-110 Oyster
  • SW-253 Green Opal
  • SW-401 Light Flux
  • SC-10 Teal Next Time  

Decorating Accessories

  • RB-144 #4 Soft Fan
  • AC-224 Plastic Detailer Cap
  • AC-223 Large Writer Tip Kit

Miscellaneous Accessories

  • Sponge
  • Water