Stroke & Coat Hareball Bunnies

Marbled Bunny:

1. Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
2. Tear off a piece of plastic wrap. It should be around 12” long. Make sure it is enough to completely cover the bunny.
3. Place the plastic wrap flat on the table. Take SC-1 Pink-A-Boo, SC-45 My Blue Heaven, SC-55 Yella Bout It and SC-85 Orkid and squirt random lines on the plastic wrap. Cover about half of the entire area.
4. Fold the plastic wrap in half. Use your fingers to spread out the glaze so that there are no bare spots.
5. Carefully unfold the plastic wrap and place it (glaze side down) over the top of the bunny. Press all areas of the bunny. Remove the plastic wrap. If there are any bare areas on the bunny, use any leftover glaze that is still on the plastic wrap, then discard.
6. If you have areas of dripping glaze, tear off a small piece of plastic wrap and press onto the area. This will spread out the glaze.
7. Dip into NT-CLR Clear Dipping Glaze.
8. Fire to cone 06.

Polka Dot Bunny

1. Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
2. Using the Soft Fan with SC-55 Yella Bout It, apply 2 coats to the entire bunny. Allow glaze to dry between coats.
3. Squeeze out around 1 TSP of SC-1 Pink-A-Boo, SC-45 My Blue Heaven and SC-85 Orkid onto the palette. Take the pencil eraser and dip it into one of the glazes, then press onto the bunny. Repeat until you have the desired number of dots for all glazes.
4. Dip into NT-CLR Clear Dipping Glaze.
5. Fire to cone 06.

Ombre Crystal Bunny:

1. Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
2. Squeeze out around 1 TBS of SC-1 Pink-A-Boo, SC-55 Yella Bout It and SC-45 My Blue Heaven onto the palette.
3. Using the Soft Fan with SC-1 Pink-A-Boo, apply 1 coat going around the bottom 1/3 of the bunny.
4. While the glaze is still wet, dip the same brush into SC-55 Yella Bout It and blend up to the center of the bunny.
5. While the glaze is still wet, dip the same brush into SC-45 My Blue Heaven and blend up to the top of the bunny.
6. Mix and shake CG-998 Pink Pixie. Pour out around 1 TBS onto the palette. You will be using this instead of SC-1 Pink-A-Boo for the next steps.
7. Using the Soft Fan with CG-998 Pink Pixie, apply 1 coat going around the bottom 1/3 of the bunny. Repeat Step #4 & Step #5.
8. Repeat Step #7.
9. Fire to cone 06.