Bloom Crystal Tile

Designer: Marcia Roullard



  1. Begin with properly fired shelf cone 04 Bisque. Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using the Soft Fan, apply two coats of S-77 Glo-Worm to the front of the tile. Let dry.
  3. Using the same brush, wet the surface of the tile with either water or a thin coat of SC-77 Glo-Worm. Place SL-431 Bloom Stencil into the wet surface and press to set into the glaze. Use a paper towel to press down the stencil to make sure glaze does not blend underneath. With a damp sponge, remove some of the glazes from the open sections of the stencil.
  4. Using the Soft Fan, apply two coats of CG-756 Firecracker over the SL-431 Boom Stencil. Allow the shine to go away between coats.
  5. When the gloss leaves the second coat of CG-756 Firecracker, remove the stencil. If some of the petals are lacking crystals apply a few more with the Script Liner.
  6. Using the Script Liner, apply one coat of SC-78 Lime Light on the open areas of the tile to create an edge of Glo-Worm around the flower.
  7. Fire to cone 05/06



  • 6″ Tile


  • SC-77 Glo-Worm
  • SC-78 Lime Light
  • CG-756 Firecracker

Decorating Accessories

  • SL-431 Bloom Stencil
  • RB-144 #4 Soft Fan
  • RB-106 #6 Script Liner

Miscellaneous Accessories

  • Sponge