Stoneware Shipwreck and White Wavy Mug

Designer: Marcia Roullard



  1. Begin with properly fired shelf cone 04 Stoneware bisque.Moisten a clean sponge and wipe bisque to remove any dust.
  2. Lay the water based marker on the table, press the mug up against the marker and rotate all the way around.  This applies a line at the bottom of the mug which is considered the “no paint” line.  Do not apply glaze past this point.
  3. Using the soft fan brush apply two coats of SW-154 Shipwreck to the outside of the mug.  Avoid the handle and the “no paint” line.
  4. Allow the glaze to dry between coats.  Dry is considered the shine is off of the glaze.
  5. Using the soft fan brush apply two coats of SW-501 White Gloss to the entire mug.  That is over the SW-154 Shipwreck, the handle and inside of the Mug.
  6. Using the sponge, remove any glaze from the no paint line or the bottom of the cup.
  7. Dry foot the cup on a kiln washed shelf.
  8. Fire to cone 6.



  • SB-103 Wavy Mug


  • SW-154 Shipwreck
  • SW-501 White Gloss

Decorating Accessories

  • RB-144 #4 Soft Fan

Miscellaneous Accessories

  • Sponge
  • Paper Towels
  • Palette
  • Water-based marker