Stroke & Coat Fall Leaves Platter

Instructions

Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
Position pattern on top of the platter. Slide AC-230 Clay Carbon Paper under the pattern. Trace the pattern with a pencil.
Using the RB-106 #6 Script Liner with SC-6 Sunkissed, SC-24 Dandelion, SC-88 Tu Tu Tango and SC-97 Cant-elope, apply 2 coats to the corresponding section of the design. Allow glaze to dry between coats. Refer to the pattern.
Prepare AC-220 Detailer Tip and 1oz Bottle. Trim the end of the tip off with scissors (just enough so you can see a hole). Squeeze SC-15 Tuxedo into the bottle until it is about half full. Screw the tip on the bottle. Outline the leaves and stems. Add decorative lines on the leaves.
Using the Soft Fan with SC-15 Tuxedo, apply 2 coats to the back of the plate. Allow glaze to dry between coats.
Using the Soft Fan with SG-703 Speckta-Clear Autumn, apply 2 coats to the front of the plate. Allow glaze to dry between coats.
Fire to cone 06.

Form

Colors

Decorating Accessories

Miscellaneous Accessories