Begin with a slab of rolled clay.
Stamp with the MT-003 Brick Mat.
Squeeze a small amount of SC-15 Tuxedo onto the palette. Thin with water. Use the soft fan to apply a thin coat over the bricks. Wipe off any excess with a damp sponge.
Draw your logo on a piece of paper or use the pattern. Make sure it will fit on the slab of clay if you draw your own.
Place the pattern over the slab of clay. Trace the pattern with the pencil. You should be able to see your lines in the clay.
Using the Script Liner with SC-73 Candy Apple Red, apply 1 coat to the top of the logo. Using the Script Liner with SC-87 Ruby Slippers, apply 1 coat to the bottom of the logo and blend with the top. Apply a total of 3 coats. Allow glaze to dry between coats.
Using the Detail Liner with SC-16 Cotton Tail, make a thick outline around the lettering. Apply a second coat after the first one is dry.
Using the Script Liner with SC-16 Cotton Tail, make dots of various sizes around and touching the logo.
Using the Script Liner with SC-6 Sunkissed, SC-11 Blue Yonder, SC-73 Candy Apple Red or SC-87 Ruby Slippers, apply 2 coats inside each of the circles.
Using the Script Liner with SC-16 Cotton Tail, add highlights to the logo.
Using the Detail Liner with SC-15 Tuxedo, outline the lettering and circles.
Allow clay to dry.
Fire to cone 04.
Red low fire clay
SC-11 Blue Yonder
SC-16 Cotton Tail
SC-73 Candy Apple Red
SC-87 Ruby Slippers
MT-003 Brick Mat
RB-144 #4 Soft Fan
RB-106 #6 Script Liner
RB-110 10/0 Detail Liner